Pleated fiberglass window screen is a material with good corrosion resistance and softness developed on the basis of glass fiber. It has two functions for building wall insulation and waterproofing. Next, please ask Pleated fiberglass window screen manufacturers to explain the construction method of Pleated fiberglass window screen in detail.

1. Pleated fiberglass window screen manufacturers formulate polymer mortar. If separation occurs, it needs to be stirred again with the mixer to ensure the quality of the mixer!

2. After weighing the amount of cement and sand in the bucket, pour it into the iron ash tank and stir. After stirring evenly, add the binder according to the mixing ratio for stirring. Mix well to avoid separation and porridge. According to the workability, water can be added appropriately.

3. Water is used for concrete.

4. The polymer mortar should be prepared as needed, and the prepared polymer mortar should be used up within 1 hour. Polymer mortar should be placed in a cool place to avoid sun exposure.

5. Cut the whole roll of Pleated fiberglass window screen into meshes according to the required length and width in advance, and leave the necessary overlapping length or the length of the overlapping part.

6. Pleated fiberglass window screen manufacturers cut in a clean and flat place, and the cutting should be accurate. The cut mesh should be rolled up and must not be folded or stepped on.

7. Make a reinforcement layer at the outer corner of the building, paste the reinforcement layer inside, 150mm on each side.

8. When applying a layer of polymer mortar, the surface of the EPS board should be kept dry, and the harmful substances or impurities on the board cotton should be removed.

9. The manufacturer of Pleated fiberglass window screen said that when scraping a layer of polymer mortar on the surface of the polystyrene board, the scraping area should be slightly larger than the length or width of the mesh cloth, and the thickness is about 2mm. Except for the requirements of edging, polymer mortar is not allowed to be applied to the side of the polystyrene board.